Table of Contents
Advertisement
Control Panel
A. LCD Display
B. MENU button
C. ENTER Button
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address the next time.)
DMX Addressing
The control panel on the front side of the base allows you to assign the DMX fixture address, which is the
first channel from which the Indigo will respond to the controller.
Please note when you use the controller, the unit has 17 channels.
When using multiple Indigo‟s, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Indigo‟s should be 1(001); the DMX address of the second Indigo
should be 1+17=18 (018); the DMX address of the third Indigo should be 18+17=35 (035), etc.
Please, be sure that you don‟t have any overlapping channels in order to control each Indigo correctly.
If two or more Indigo‟s are addressed similarly, they will work similarly.
For address settings, please refer to the instructions under "Addressing‟.
Controlling:
After having addressed all Indigo fixtures, you may now start operating these via your lighting controller.
Note: After switching on, the Indigo will automatically detect whether DMX 512 data is received or not.
there is
no data received at the DMX-input, the "LED " on the control panel will not flash.
The problem may be:
- The XLR cable from the controller is not connected with the input of the Indigo.
- The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It‟s necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
D. Down Button
E. Up Button
12
Fig. 5
If
Advertisement
Table of Contents
