Service Manual – SC401, SCRUBTEC 344
Operator's Presence Sensors (S1, S2)
1
After removing the user interface controller cover and its connections, unscrew the 4 screws (G) then
remove the handlebar (H)
2
At the workbench, unscrew the 7 screws (I) the open the two handlebar parts front and back
3
Disconnect the connection (J), with the screwdriver carefully remove the operator's presence sensor (K)
detaching it from the support
4
Clean the support area from the glue remained of the operator's presence sensor removed
G
G
Figure 23:
5
Assemble the components in the reverse order of dissasembly
Note: The new operator's presence sensor is provided with an self-adhesive seat for assembling.
H
G
G
J
I
I
I
04 - Control System - Battery
I
I
K
45