Repairs, when required, should be performed by your Authorized Nilfi sk-Advance Service Center, who employs factory trained service personnel, and maintains an inventory of Nilfi sk-Advance original replacement parts and accessories. Call the NILFISK-ADVANCE DEALER named below for repair parts or service. Please specify the Model and Serial Number when discussing your machine. (Dealer, affi x service sticker here.) NAME PLATE The Model Number and Serial Number of your machine are shown on the Nameplate on the machine.
Do not use on surfaces having a gradient exceeding that marked on the machine. All doors and covers are to be positioned as indicated in the instruction manual before using the machine. SAVE THESE INSTRUCTIONS revised 11/06 FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series - A-3 ™ ™...
Toutes les portes et couvercles doivent être dans la position mentionnée dans le manuel d’instruction avant de mettre la machine en service. CONSERVEZ SOIGNEUSEMENT CES INSTRUCTIONS revised 11/06 A-4 - FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series ™ ™...
Install the battery boots and secure tightly to the battery cables with the supplied tie straps. Connect the battery pack connector to the machine connector (22) and close the battery compartment cover. FIGURE 1 FRONT revised 11/06 FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series - A-7 ™ ™...
Slide the brush into the housing, lift slightly, push and turn until it seats. Re-install the idler assemblies, close the skirt assemblies and secure with cotter pins. A-8 - FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series ™ ™...
Use only low-foaming, non-fl ammable liquid detergents intended for automatic scrubber machine applications. Water temperature should not exceed 130 degrees Fahrenheit (54.4 degrees Celsius). FIGURE 2 FRONT revised 3/06 FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series - A-9 ™ ™...
DISPOSABLE CARTRIDGE SPECIFIC INSTRUCTIONS: Remove the Cap (CC) and place the cartridge in the detergent box. Install the Dry Break Cap (DD) as shown. revised 3/06 A-10 - FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series ™ ™...
Page 11
ENGLISH / A-11 DETERGENT SYSTEM PREPARATION AND USE (AXP/EDS MODELS ONLY) FRONT revised 3/06 FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series - A-11 ™ ™...
OFF. NOTE: If the control repeatedly gives a full indication when the tank is not full, the automatic shut-off feature can be disabled, have a qualifi ed service technician perform this function. revised 3/06 A-12 - FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series ™ ™...
• Steering Chain • General Pivot Points For the Squeegee, Brush Linkage and Side Skirts • Squeegee mount angle adjustment knob threads revised 3/06 FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series - A-13 ™ ™...
Tighten the vent caps. If there is acid on the batteries, wash the tops of the batteries with a solution of baking soda and water (2 tablespoons of baking soda to 1 quart of water). A-14 - FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series ™ ™...
Turn the Adjustment Knob (E) to tilt the tool forward or backwards, until the rear squeegee wiping blade touches the fl oor evenly across its entire width. Re-tighten by hand the Lock Wing Nut (D). FIGURE 3 FRONT FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series - A-15 ™ ™...
Note: Make small adjustments to obtain good blade wiping. Do not lower the blades too much to where they fold over excessively and cause unneeded blade wear. FIGURE 4 A-16 - FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series ™ ™...
Page 17
See Figure 5. Remove the (2) (A) Cotter Pins and swing the Skirt Assemblies open. Remove the (B) Screws and Nuts, remove the Skirts and replace. FIGURE 5 FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series - A-17 ™ ™...
Dry seal cap on detergent cartridge not sealed Reseat dry seal cap Detergent ratio slider magnet missing Replace slider Detergent pump wiring Connect or reconnect wiring disconnected or backwards revised 3/06 A-18 - FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series ™ ™...
Page 19
Vibrations at the Seat (EN 1032) 0.35m/s 0.35m/s 0.35m/s Gradeability Transport 20% (11.5 20% (11.5 20% (11.5 Cleaning 8% (4.6 8% (4.6 8% (4.6 revised 3/06 FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series - A-19 ™ ™...
Page 20
Nilfi sk-Advance originales. Llame al DISTRIBUIDOR NILFISK-ADVANCE que se indica a continuación para lo referente a piezas de repuesto y servicio. Por favor, especifi que el Modelo y Número de Serie cuando hable de su máquina.
Antes de utilizar la máquina, todas las puertas y cubiertas deberían estar colocadas como se indica en el manual de instrucciones. GUARDE ESTAS INSTRUCCIONES revised 11/06 FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series - B-3 ™ ™...
Panel de control Botón de ajuste de la inclinación de la boquilla Palanca de ajuste del asiento del operador Smart Solutions™ / ECO Solution™ B-4 - FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series ™ ™...
Indicador del sistema de aspiración Pantalla de presión de fregado/cronómetro Indicador del sistema de solución Indicador del interruptor de la vara Interruptor de solución Interruptor de la vara FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series - B-5 ™ ™...
Conecte el conector del conjunto de las baterías al conector de la máquina (22) y cierre la tapa del compartimento de baterías. FIGURA 1 FRONT revised 11/06 B-6 - FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series ™ ™...
Utilice únicamente detergentes líquidos no infl amables de bajo poder espumante que estén diseñados para aplicaciones de fregado automático. La temperatura del agua no deberá superar los 130 grados Fahrenheit (54,4 grados Celsius). FIGURA 2 FRONT revised 3/06 FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series - B-7 ™ ™...
INSTRUCCIONES ESPECÍFICAS DEL CARTUCHO DESECHABLE: Retire la tapa (CC) y coloque el cartucho en la caja de detergente. Instale la tapa sellada (DD) como se muestra. revised 3/06 B-8 - FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series ™ ™...
Page 27
ESPAÑOL / B-9 REPARACIÓN Y USO DEL SISTEMA DE DETERGENTE (AXP/EDS) FRONT revised 3/06 FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series - B-9 ™ ™...
NOTA: Si el control indica constantemente que el tanque está lleno cuando no lo está, se puede deshabilitar la opción de cierre automático, cosa que debe hacer un técnico de mantenimiento cualifi cado. revised 3/06 B-10 - FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series ™ ™...
Puntos generales de pivotaje de la boquilla, junta de cepillo y faldillas laterales • Hilos del botón de ajuste del ángulo de montaje de la boquilla revised 3/06 FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series - B-11 ™ ™...
Apriete las cubiertas de ventilación. Si hay ácido en las baterías, limpie la parte superior con una solución de levadura química y agua (2 cucharadas de levadura química en 1 cuarto de agua [aprox. 1 litro]). B-12 - FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series ™ ™...
Gire el botón de ajuste (E) para inclinar la herramienta hacia delante o hacia atrás, hasta que la cuchilla secadora de la boquilla trasera toque el suelo de manera uniforme en toda su anchura. Vuelva a apretar a mano la tuerca de palomilla de cierre (D). FIGURA 3 FRONT FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series - B-13 ™ ™...
Nota: Haga pequeños ajustes para conseguir un buen secado con las cuchillas. No baje las cuchillas demasiado para que no se plieguen en exceso y no se produzcan un desgaste innecesario de las cuchillas. FIGURA 4 B-14 - FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series ™ ™...
Page 33
Ver la Figura 5. Retire los (2) (A) pasadores y abra los conjuntos de faldillas. Retire los (B) tornillos y las tuercas, retire las faldillas y sustitúyalas. FIGURA 5 FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series - B-15 ™ ™...
Page 34
Falta imán en el deslizador de mezcla de Sustituir deslizador detergente Cableado de la bomba de detergente Conectar o reconectar cableado desconectado o hacia atrás revised 3/06 B-16 - FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series ™ ™...
Page 35
Vibración en el asiento (EN 1032) 0.35m/s 0.35m/s 0.35m/s Capacidad ascendente Transporte 20% (11.5 20% (11.5 20% (11.5 Limpieza 8% (4.6 8% (4.6 8% (4.6 revised 3/06 FORM NO. 56041583 - Adgressor , Adgressor AXP / BR 850S series - B-17 ™ ™...
Need help?
Do you have a question about the BR 850S Series and is the answer not in the manual?
Questions and answers