Changing The User Pin In Admin Mode; Deleting The User Pin In Admin Mode - iStorage datAshur Pro2 User Manual

12. Changing the User PIN in Admin Mode

Important: Changing the User PIN must comply with the 'User PIN Policy' if one has been configured as
described in section 8, which imposes a minimum PIN length and whether a 'Special Character' has been
used. Refer to section 10 to check the user PIN restrictions.
To change an existing User PIN, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin
Mode (solid BLUE LED) proceed with the following steps.
1. In Admin mode press and hold down both
KEY ( ) + 3 buttons
2. Enter New User PIN and press KEY ( ) button
3. Re-enter the New User PIN and press KEY ( )
button again
Note: When the datAshur PRO
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur PRO
solid BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
(data), the datAshur PRO

13. Deleting the User PIN in Admin Mode

To delete an existing User PIN, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode
(solid BLUE LED) proceed with the following steps.
1. In Admin mode press and hold down both
SHIFT ( ) + 3 buttons
2. Press and hold down both
SHIFT ( ) + 3 buttons again
#14
is in Admin Mode, the
2
RED LED which then fades out to the Idle state (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To access the drive contents
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
2
www.istorage-uk.com
Solid BLUE
and solid BLUE
Blinking GREEN
switch to a single
back to blinking
Blinking GREEN
to a rapidly blinking
a solid BLUE
been successfully changed
BLUE LED will remain on and solid for 30 seconds only,
will exit Admin mode automatically - the
2
Solid BLUE
LED
Blinking RED
LED and then to a solid
the User PIN has been successfully deleted
LED will change to blinking
LEDs
and solid BLUE LEDs will
GREEN LED blink and then
GREEN and solid BLUE
and solid BLUE LEDs change
GREEN LED and finally to
LED indicating the User PIN has
) button for a second - the
LED will change to a blinking
LED will change to a solid
BLUE LED indicating
GREEN
LEDs
RED
RED