How To Perform A Complete Reset; How To Configure Datashur Pro; As Bootable - iStorage datAshur Pro2 User Manual

35. How to perform a complete reset

To perform a complete reset, the datAshur PRO
Admin/User PINs, the encryption key and all data will be deleted and lost forever and the drive will need to be formatted
before it can be reused. To reset the datAshur PRO
1. In standby state (solid
hold down "0" button
2. Press and hold down both 2 + 7 buttons
Important: After a complete reset a new Admin PIN must be configured, refer to Section 26 on page 22 on

36. How to configure datAshur PRO

Note: When the drive is set as bootable, ejecting the drive from Operating System will
iStorage datAshur PRO
2
process. When booting from the datAshur PRO
the datAshur PRO .
2
To set the drive as bootable, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode
(solid BLUE LED) proceed with the following steps.
1. In Admin mode, press and hold down both
KEY ( ) + 8 buttons
2. Press "0" followed by a "1" (01)
3. Press the SHIFT (
Note: When the datAshur PRO
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur PRO
solid BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
(data), the datAshur PRO
#28
must be in standby state (solid
2
proceed with the following steps.
2
RED LED) , press and
to Configure an Admin PIN after a Brute Force attack or
formatted before any new data can be added to the drive.
not force the LED to turn RED. The drive stays solid
next time use. The default setting of the datAshur PRO
USB drives are equipped with a bootable feature to accommodate power cycling during a host boot
, you are running your computer with the operating system that is installed on
2
) button once
is in Admin Mode, the
2
RED LED which then fades out to the Idle state (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To access the drive contents
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
2
RED
Solid
GREEN
off
RED, GREEN
become solid for a second and then to a solid
RED LED indicating the drive has been reset
Reset', the datAshur PRO

as Bootable

2
GREEN
is configured as non-bootable.
2
Solid
and BLUE
GREEN
Blinking
a solid
LED indicating the drive has been successfully
configured as bootable
BLUE LED will remain on and solid for 30 seconds only,
will exit Admin mode automatically - the
2
www.istorage-uk.com
LED). Once the drive is reset then all
RED LED will change to all LEDs, RED,
and BLUE blinking alternately on and
and BLUE alternating LEDs will
will also need to be
2
and needs to be unplugged for
BLUE LED will change to blinking
LEDs
and BLUE LEDs will continue to blink
GREEN and BLUE LEDs will change to
GREEN LED and finally to a solid
) button for a second - the
'How
GREEN
BLUE