How To Configure A Self-Destruct Pin - iStorage datAshur Pro2 User Manual

Note: When the datAshur PRO
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur PRO
solid BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
(data), the datAshur PRO

23. How to configure a Self-Destruct PIN

You can configure a self-destruct PIN which when entered performs a Crypto-Erase on the drive (encryption key is deleted).
This process deletes all configured PINs and renders all data stored on the drive as inaccessible (lost forever), the drive will
then show as unlocked GREEN
the drive will need to be formatted before it can be reused.
To set the Self-Destruct PIN, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode
(solid BLUE LED) proceed with the following steps.
1. In Admin mode, press and hold down both
KEY ( ) + 6 buttons
2. Configure a 7-15 digit Self-Destruct PIN and
press the KEY ( ) button
3. Re-enter the Self-Destruct PIN and press
the KEY ( ) button
Note: When the datAshur PRO
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur PRO
solid BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
(data), the datAshur PRO
#20
is in Admin Mode, the
2
RED LED which then fades out to the Idle state (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To access the drive contents
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
2
LED. Running this feature will cause the self-destruct PIN to become the new User PIN and
is in Admin Mode, the
2
RED LED which then fades out to the Idle state (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To access the drive contents
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
2
www.istorage-uk.com
BLUE LED will remain on and solid for 30 seconds only,
will exit Admin mode automatically - the
2
Solid BLUE
and solid BLUE
Blinking GREEN
switch to a single
back to blinking
GREEN LED will rapidly blink for several
seconds and then changes to a solid
to indicate the Self-Destruct PIN has been
successfully configured
BLUE LED will remain on and solid for 30 seconds only,
will exit Admin mode automatically - the
2
) button for a second - the
LED will change to blinking
LEDs
and solid BLUE LEDs will
GREEN LED blink and then
GREEN and solid BLUE
BLUE
) button for a second - the
GREEN
LEDs
LED