How To Configure An Admin Pin After A Brute Force Attack Or Reset; Setting The Unattended Auto-Lock Clock - iStorage datAshur Pro2 User Manual

26. How to Configure an Admin PIN after a Brute Force attack or Reset

It will be necessary after a Brute Force attack or when the datAshur PRO
drive can be used.
PIN Requirements:
• Must be between 7-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
If the datAshur PRO has been brute forced or reset, the drive will be in standby state (solid
2
PIN proceed with the following steps.
1. In Standby state (solid
down both SHIFT (
2. Enter New Admin PIN and press KEY ( )
button
3. Re-enter the New Admin PIN and press
KEY ( ) button
Note: When the datAshur PRO
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur PRO
solid BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
(data), the datAshur PRO

27. Setting the Unattended Auto-Lock Clock

To protect against unauthorised access if the drive is unlocked and unattended, the datAshur PRO
automatically lock after a pre-set amount of time. In its default state, the datAshur PRO
feature is turned off. The Unattended Auto Lock can be set to activate between 5 - 99 minutes.
#22
RED LED), press and hold
) + 1 buttons
is in Admin Mode, the
2
RED LED which then fades out to the Idle state (all LEDs off).
LED), press and hold down the SHIFT (
BLUE
RED LED which then fades out to the Idle state. To access the drive contents
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
2
has been reset to configure an Admin PIN before the
2
Solid
and solid
Blinking
switch to a single
back to blinking
Blinking
change to
seconds and then to a solid
ing the Admin PIN was successfully configured.
BLUE LED will remain on and solid for 30 seconds only,
will exit Admin mode automatically - the
2
www.istorage-uk.com
RED LED). to configure an Admin
RED LED will change to blinking
BLUE LEDs
GREEN and solid BLUE
GREEN LED blink and then
GREEN and solid
GREEN LED and solid BLUE
BLUE LED rapidly blinking for a few
BLUE
) button for a second - the
can be set to
2
Unattended Auto Lock time-out
2
GREEN
LEDs will
BLUE LEDs
LED
LED indicat-