How To Delete The User Pin Policy - iStorage datAshur Pro2 User Manual

Note: When the datAshur PRO
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur PRO
solid BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
(data), the datAshur PRO

9. How to delete the User PIN Policy

To delete the User PIN Policy, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode
(solid BLUE LED) proceed with the following steps.
1. In Admin mode, press and hold down both
KEY ( ) + 7 buttons
2. Enter 070 and press SHIFT (
Note: When the datAshur PRO
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur PRO
solid BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
(data), the datAshur PRO
is in Admin Mode, the
2
RED LED which then fades out to the Idle state (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To access the drive contents
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
2
) button once
is in Admin Mode, the
2
RED LED which then fades out to the Idle state (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To access the drive contents
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
2
www.istorage-uk.com
BLUE LED will remain on and solid for 30 seconds only,
will exit Admin mode automatically - the
2
Solid BLUE
and BLUE
Blinking GREEN
a solid GREEN
LED indicating the User PIN Policy has been
successfully deleted
BLUE LED will remain on and solid for 30 seconds only,
will exit Admin mode automatically - the
2
) button for a second - the
LED will change to blinking
LEDs
and BLUE LEDs will change to
LED and finally to a solid
) button for a second - the
GREEN
BLUE
#11