How To Change The User Pin; How To Create A New User Pin - When All Cryptographic Parameters Have Been Zeroed - iStorage datashur personal User Manual

personal

4. How to change the User PIN

PIN requirements:
• Must be between 7-15 digits in length
• Must not contain only repetitive numbers e.g. 3-3-3-3-3-3-3
• Must not contain only consecutive numbers e.g. (1-2-3-4-5-6-7),(7-8-9-0-1-2-3-4),(7-6-5-4-3-2-1)
Drive must NOT be connected to a host
•
INSTRUCTIONS
Press KEY Button
Enter User PIN to unlock drive
(Factory default PIN 1,1,2,2,3,3,4,4)
and press KEY Button
Press and hold KEY Button
illuminated enter New User PIN
While
and press KEY Button
Re-enter New User PIN
and press KEY Button
Insert datAshur Personal into USB port
Note:
5. How to create a new User PIN
when all cryptographic parameters have been zeroed
All cryptographic parameters (including User PIN and Admin PIN) are zeroed after hacking detection
has been triggered by 10 consecutive failed attempts to unlock, or when the drive has been manually
reset (see section No. 12)
This state is evident by a solid lit
following these instructions.
Once the User PIN has been defined, a new encryption key is generated using the on-board random
number generator.
Configuring a New User PIN overleaf
#6
for 3 seconds
If a mistake was made while defining a new PIN or the procedure was aborted,
the drive will retain the old PIN.
RED LED indicator. It will be necessary to set a New User PIN by
www.istorage-uk.com
LED ACTIVITY
will blink together
will illuminate together for approximately
4 seconds and then:
will blink indicating correct PIN entry
will illuminate together
will blink in unison
will illuminate and then
change to blinking
N.B.
blinks if 1 and 2
st
blink alternately if PIN entry incorrect
entries match
nd