Adding A New User Pin; Deleting The User Pins; Changing The User Pin - iStorage diskashur PRO SSD User Manual

9. Adding a new User PIN

1. Enter the Admin Mode
2. Press and hold
3. Enter a User PIN and press
The LED flashes
4. Re-enter the new User PIN and press UNLOCK. If the LED stays solid
seconds and then solid BLUE, the User PIN was successfully added.

10. Deleting the User PINs

You can delete ALL User PINs by doing the following:
1. Enter the Admin Mode
2. Press and hold 7 + 8 +
times and then changes to
3. Press and hold 7 + 8 +
solid GREEN
PINs were deleted successfully.

11. Changing the User PIN

You can change the User PIN by doing the following:
1. Unlock the drive by inputting your User PIN and pressing the
2. Press and hold
3. Enter your current PIN and press UNLOCK.
The LED will be Solid
4. Enter the new PIN and press
a maximum of 16 digits). The LED will flash
BLUE and Blinking GREEN.
5. Re-enter the new User PIN and press UNLOCK. The LED stays solid
indicating that the User PIN has been changed successfully.
(UNLOCK + 0 buttons for five seconds. Enter Admin PIN and press UNLOCK).
UNLOCK + 1 buttons until the LED turns to Solid
UNLOCK
(a minimum of 7 digits and a maximum of 16 digits).
GREEN
three times, then returns to Solid
(UNLOCK + 0 buttons for five seconds. Enter Admin PIN and press UNLOCK).
UNLOCK buttons for five seconds until the LED flashes
BLUE / RED alternating.
UNLOCK buttons a second time for five seconds until the LED goes on
for two seconds and then back to solid BLUE, this indicates that the User
UNLOCK + 1 buttons until the LED flashes RED.
BLUE and Solid GREEN.
UNLOCK (The PIN must be a minimum of 7 digits and
www.istorage-uk.com
BLUE
BLUE and Blinking GREEN.
GREEN
UNLOCK
GREEN three times, then returns to Solid
GREEN
and Blinking GREEN.
for two
GREEN three
button.
#9