Adding A New User Pin In Admin Mode; Changing The User Pin In Admin Mode; Deleting The User Pin In Admin Mode - iStorage diskAshur DT2 User Manual

9. Adding a new User PIN in Admin Mode

To add a New User, first enter the "Admin Mode" as described in section 7. Once the drive is in Admin Mode
(solid BLUE LED) proceed with the following steps.
1. In Admin mode, press and hold down
"UNLOCK + 3" buttons
2. Enter New User PIN and press "UNLOCK" button
3. Re-enter the New User PIN and press "UNLOCK"
button

10. Changing the User PIN in Admin Mode

To change an existing User PIN, first enter the "Admin Mode" as described in section 7. Once the drive is in Admin
Mode (solid BLUE LED) proceed with the following steps.
1. In Admin mode, press and hold down
"UNLOCK + 3" buttons
2. Enter New User PIN and press "UNLOCK" button
3. Re-enter the New User PIN and press "UNLOCK"
button

11. Deleting the User PIN in Admin Mode

To delete a User PIN, first enter the "Admin Mode" as described in section 7. Once the drive is in Admin Mode
(solid BLUE LED) proceed with the following steps.
1. In Admin mode, press and hold down "SHIFT + 3"
buttons and release
2. Press and hold down "SHIFT + 3" buttons again.
#10
Solid
and solid
Blinking
switch to a single
back to blinking
GREEN
then changes to a solid
User PIN has been successfully created
Solid
and solid
Blinking
switch to a single
back to blinking
GREEN
then changes to a solid
User PIN has been successfully changed
Solid
LED
Blinking
LED and then to a solid
the User PIN was successfully deleted
www.istorage-uk.com
BLUE LED will change to blinking
BLUE LEDs
GREEN and solid BLUE
GREEN LED blink and then
GREEN and solid
LED rapidly blinks for a few seconds
BLUE LED indicating the
BLUE LED will change to blinking
BLUE LEDs
GREEN and solid BLUE
GREEN LED blink and then
GREEN and solid
LED rapidly blinks for a few seconds
BLUE LED indicating the
BLUE LED will change to blinking
RED LED will change to solid
BLUE LED indicating
GREEN
LEDs will
BLUE LEDs
GREEN
LEDs will
BLUE LEDs
RED
RED