Advertisement
10 Install Inside Module Component Assembly
1. Insert top tabs of controller into slots on mounting plate (Fig. 10).
2. Ensure proper alignment of board-to-board connectors while pivoting bottom
of controller toward door until tab on bottom snaps securely into place on
mounting plate.
CAUTION: To avoid possible damage to board-to-board connectors,
care should be taken when securing controller to mounting
plate. If there is resistance when securing, detach controller
to determine cause before re-attaching controller.
1-800-810-WIRE • www.sargentlock.com • A8185A
Fig. 10
28
IN120 Exit Device
Hide quick links:
Advertisement
