Assa Abloy SARGENT IN120 Installation Instructions Manual page 27

IN120 Exit Device
9 Installation of Connectors
CAUTION - Do not touch or allow debris to enter connector contacts.
Secure the following connectors to their respective terminals (Fig. 9A, B):
A. Secure the 4-pin DPS connector.
B. Secure the 10-pin lock body assembly connector.
*NOTE: Optional 2-pin external 9-24VDC power connector.
IMPORTANT: Do not run wires through bottom hole in plate (Fig. 9A, B)
- it will damage wires and the controller connector. Route wires around
flange, do not route wires through the flange hole (Fig. 9B).
Secure Mounting Plate
1. Tuck excess cable into wire hole on inside of door.
2. Secure the mounting assembly while ensuring proper
alignment of outside reader and fully tighten the (2) through-
bolts on the inside of the door to secure the reader and
plate to the door.
C. Secure the 24-pin card reader connector (Fig. 9B).
Ground
Lug
Reader
(24-pin)
Board-to-Board
Connector
27 1-800-810-WIRE • www.sargentlock.com • A8185A
9-24VDC
Power*
A
DPS (4-pin)
B
Fig. 9A
Lock
Body
(10-pin)
C
Fig. 9B