Advertisement
IN120 Exit Device
12 Battery Installation
Before installing batteries for the first time:
Remove pull tab from its position beneath the coin cell by pulling
on tab in direction of arrows printed on tab (Fig. 11).
1. Place (6) "AA" alkaline batteries in the compartment, being
careful to align polarity properly.
2. After batteries are installed, there is a slight delay; then an
audible "beep" will sound and the lock motor will cycle.
13 Inside Cover Installation
1. Assemble cover by hooking top edge on inside
mounting plate.
2. Carefully press bottom of cover toward door without
pinching any wires.
3. Secure cover utilizing security allen wrench.
Fig. 11
17
1-800-810-WIRE • www.sargentlock.com • A8185A
AA
Batteries (6)
Coin Cell
Pull Tab
Inside
Cover
Security Allen
Screw
Hide quick links:
Advertisement
