Assa Abloy SARGENT IN120 Installation Instructions Manual page 20

2 Install Door Position Switch (DPS)
Wood doors have 3/8" raceway to controller cutout and metal doors
have 3/4" raceway to the controller cutout.
Refer to template A8215.
1. Insert connector end of DPS through the raceway on the latch edge of
the door (Fig. 2A).
Note: For metal doors, use DPS Collar.
2. Push DPS firmly into place by hand.
: DO NOT TAP SWITCH WITH ANY TOOL.
IMPORTANT
DPS
(Door Position
Switch)
Collar is used only
with metal doors
1-800-810-WIRE • www.sargentlock.com • A8185A
Fig. 2A
Door Frame
Wood Frame Metal Frame
Dim 1
3/8" 3/4"
(From template)
20
DPS
(Door Position
Switch)
Dim 1
Dim 2
Horizontal
of Strike
Fig. 2B
IN120 Exit Device
Door Position
Switch Hole
Vertical
of Strike