Advertisement
4 Position Exit Trim (ET)
NOTE: For exterior applications, use ET gasket (52-0263) as a seal between
ET escutcheon and outside door surface.
A. Connect motor harness adapter to chassis harness connector (Fig. 4).
B. For wood doors: Route ET wire harness connector through the cylinder hole,
up and through the wire run channel to the controller cutout.
For metal doors: Route ET wire harness through the cylinder hole out the
controller cutout.
C. Pass top ET trim mounting post through chassis harness ground lug.
D. Ensure ET spindle engages the lower hub of the exit chassis.
E. Begin to secure chassis to ET trim by partially tightening (2) chassis through
bolts (Fig. 4B).
Do not fully tighten at this time.
Outside of Door
D
1-800-810-WIRE • www.sargentlock.com • A8185A
NOTE: Cable lengths exaggerated for illustrative purposes.
B
C
A
Fig. 4A
22
IN120 Exit Device
Fig. 4B
Inside of Door
Partially
Tighten
E
Hide quick links:
Advertisement
