Storage - AUMA SG 05.1 Operation Instructions Manual

14. STORAGE

The following are short-term storage instructions (Less than 12 Months):
• Actuators should be stored in a clean, dry, protected environment, free from excessive vibration
and rapid temperature changes. If actuators must be stored outdoors, they must be stored high
enough off the ground to prevent being immersed in water or buried in snow.
• All covers must remain in place and retaining bolts tightened.
• Conduit entries must be sealed with threaded metal plugs.
• O-ring seals must remain intact and undisturbed.
• Desiccant should be placed in the limit switch compartment and the control compartment, if
supplied, and replaced as necessary according to the desiccant manufacturer's instructions.
Desiccant is not supplied with the actuator as shipped unless prior arrangements have been made.
• The actuators must be covered with an unsealed dust cover with breather holes to allow air to
move around the actuator.
• Failure to comply with recommended storage will void warranty.
• For long-term storage (more than 12 months), consult the factory.
13