Customer Acceptance; Task 12-1: Alarm Origination Administration; Test And Status Mo Disk - Lucent Technologies DEFINITY AUDIX Installation And Administration Manual

Installation and Switch Administration for G3i/G3s/G3vs/R5vs/R5si/ProLogix
Switches, TN2181 Emulation, Display Set Integration 585-300-122
10

Customer Acceptance

Alarm Origination Administration Test and Status MO Disk
Customer Acceptance
With the exception of
Manager must complete with the customer to hand the DEFINITY AUDIX system
over to the customer. Most of these tasks are part of the Streamlined
Implementation process. Therefore, they are not described fully in this document,
but are listed here as a final check to make sure they are completed.
Task 10-1: Alarm Origination Administration

Test and Status MO Disk

Worksheet C-9
through switch only , or through audix & switch . If alarm origination is to be set up through
the switch only, skip to Step 9 of this task.
You will perform this task jointly with personnel at the INADS center, which is part of the
T echnical Services Organization (TSO) at Lucent.
The steps listed below present a typical execution of this task. The steps for this site may
vary, depending on the approach you agree upon with the INADS personnel.
1. Call the INADS center and request administration and test of alarm origination for
this DEFINITY AUDIX system.
2. If you have not already done so, log in to the DEFINITY AUDIX system terminal as
craft. Refer to
3. Type change system-parameters maintenance and press
The system displays the System-Parameters Maintenance screen
Task 10-1, this chapter lists the tasks that the Project
indicates whether alarm origination is to be activated through AUDIX only ,
T ask 5-1A for the login procedure.
Issue 1
May 1999
10
.
RETURN
10-1