System Configuration - Gatekeeper Systems Digital Smart Recorder NiTRO 900 Manual

STP, BRK, WRN, 1EX, 2EX. Each label can be
changed (maximum 5 characters long).
Cam: Cam: Cam: Cam: You can select which camera should
become active when the associated sensor is
active.
Trg Trg Trg: : : : Trg The trigger defines either to trigger on an
active high (1) or active low (0).
SENSOR READINGS
PURPOSE PURPOSE: The Sensor readings menu displays all sensors that can be displayed in the subtitles. The default sensors are PURPOSE PURPOSE
automatically displayed and cannot be turned off–they will always appear in the subtitles when they are active.
Sensor Readings can also be used to test whether sensors are working: 0 is displayed while the current sensor is inactive,
and 1 is displayed when the sensor is active.
T and V are the temperature and voltage of the system and can be turned on or off from being displayed in the subtitles.
The GPS is the GPS position of the vehicle, and speed_mph is the speed of the vehicle.
ENTRY: Press 'Go' to enter the Sensor Readings ENTRY ENTRY ENTRY
menu. Use the left or right arrow keys to scroll to the
next sensor in the list. The T, V, and GPS sensors can
be turned off or on.
OTHER: The speed units used will be correct OTHER OTHER OTHER
according to the units configured in the Set Units
menu (ie. if the unit is set to Metric units, the speed
will be recorded in kph, even though the sensor label
reads speed_mph).
Refer to the Sensor Pin-out diagram on page 11 Figure 2 for connection pin-outs.
Use the menu control buttons to navigate to SYSTEM and press GO.

System Configuration

System Configuration System Configuration System Configuration. . . .
There are eight menus under the SYSTEM sub menu. The menus are defined below. Refer to the following pages for a
detailed description of how to use each menu.
The disk used menu displays the percentage of storage spaced used up on the disk.
DISK USED
The unique serial number of the recorder is displayed. This serial number is also the default ID that is
SERIAL
displayed under Set ID.
IP0 When the recorder is connected to a LAN via the back Ethernet port, the IP address will be displayed.
When the recorder is connected to a laptop via the front USB port using the USB to Ethernet adaptor,
IP1
the IP address 192.168.1.1 will be displayed.
Utility used to poll the DHCP server.
DHCP REFRESH
The currently installed software version is displayed.
S/W VERSION
EXIT: Press the blue menu button to exit the Sensor Readings EXIT EXIT EXIT
menu and return to the Advanced sub menu.
DEFAULT CONDITION: Sensors 1-8 – On, Temp, Voltage, GPS, etc. DEFAULT CONDITION DEFAULT CONDITION DEFAULT CONDITION
-29-
high (1)
– Off