Quick Configuration Settings For Installers - Gatekeeper Systems Digital Smart Recorder NiTRO 900 Manual

Quick Configuration Settings for Installers. . . .

Quick Configuration Settings for Installers Quick Configuration Settings for Installers Quick Configuration Settings for Installers
The Configuration menu allows the user the ability to fully customize each system. To access the configuration menu, press
and release the Blue menu button to the left of the LCD screen. Press and release this button until the Configuration option
appears on the LCD and then press GO using the button below it on the LCD screen. After you have changed a value under
a particular menu, you will see a message stating "Saving Config", this message wil appear for five seconds. Once
completed you will see a second message stating "Config Saved" this will also appear for five seconds. Use the on-screen
Right and Left arrows to choose Basic, Advanced or System and then press GO.
The Configuration menu is separated into three sub menus: Basic, Advanced and System. Use the menu control buttons
to navigate to BASIC and press GO.
Lens Setup Lens Setup Lens Setup Lens Setup Can use to aim and focus camera(s)
Set ID Set ID Set ID Set ID Set as "Bus Number", e.g. Bus 123
Set Timezone Set Timezone Scroll to correct time-zone for geographic area
Set Timezone Set Timezone
Set Date Set Date Check to make sure date and time are correct
Set Date Set Date
Record Extend Record Extend Determines the number of minutes the system will record after the ignition
Record Extend Record Extend
has been switched off
Audio Audio Audio Audio If dual audio is required change this setting to Stereo.
Reset Reset Reset Reset Once Quick Configuration is complete, choose the Reset Option and then select VIDEO ONLY. This
will ensure that the customer will receive the system without any previous video on their comrad™
All other settings are set by default; refer to the following pages for details if you wish to configure more settings
If all camera(s) connected to the If all camera(s) connected to
If all camera(s) connected to If all camera(s) connected to
Camera Type Camera Type
Camera Type Camera Type
If more than one camera is connected to the If more than one camera is connected to the If more than one camera is connected to the If more than one camera is connected to the NiTRO
Cameras Cameras
Cameras Cameras
If you want to record from each camera with even time dwell: : : : If you want to record from each camera with even time dwell If you want to record from each camera with even time dwell If you want to record from each camera with even time dwell
Camera Dwell Camera Dwell
Camera Dwell Camera Dwell
If you want to record from one camera and switch to another only when a sensor is activated If you want to record from one camera and switch to another only when a sensor is activated, (ie. Switch to stop If you want to record from one camera and switch to another only when a sensor is activated If you want to record from one camera and switch to another only when a sensor is activated
arm camera when stop arm is active):
Camera Dwell Camera Dwell Camera Dwell Camera Dwell
Sensor Setup Sensor Setup
Sensor Setup Sensor Setup
NiTRO™ ™ ™ ™ 900
the NiTRO 900 are black & white: are black & white:
the the NiTRO NiTRO 900 900 are black & white: are black & white:
Set to Black & White
NiTRO™ ™ ™ ™ 900
NiTRO NiTRO
Select the number of cameras (1 - 4) connected to the NiTRO™ 900
Set to appropriate dwell time, ie. 10 seconds per camera
Set to Sensors
Configure the appropriate sensor to switch to the correct camera when active
-20-
900: : : : 900 900