Installing The Dome Camera; Bulkhead Mount; Figure 10: Removing Outer And Polycarbonate Dome; Figure 11: Camera Seat Position - Gatekeeper Systems Digital Smart Recorder NiTRO 900 Manual

Installing the Dome Camera

Installing the Dome Camera. . . . Installing the Dome Camera Installing the Dome Camera
1. Disassemble the dome camera by removing the outer polycarbonate
dome. Loosen Phillips screws to allow camera board to move freely.
2. Ensure the included gasket is in place between dome baseplate and
mounting surface. This gasket is required as it acts as a cushion to
absorb vibration and aid in elimination of wind noise from the roof of the
bus. Determine seat position for camera harness and insert camera
harness into seat position.
Attach the Molex connector from camera harness to the Molex connector attached to the camera circuitry.
3. If mounting to Bulkhead of the bus follow 'Bulkhead Mount' instructions on the following page.
4. Tuck attached camera harness behind the camera circuitry and then mount base with the four screws supplied
(Figure 12, Page 21).
5. Focus camera by referring to 'Focusing Camera Lens' on the following page.
6. After final check re-attach Polycarbonate dome cover and outer dome with hex screws.
Do not clean polycarbonate dome with any agents.
Bulkhead Bulkhead Bulkhead

Bulkhead Mount

Mount Mount. . . . Mount
Remove the two bracket mounting screws.
Rotate camera mount 180° (upside down) and reattach to base
plate.
Return to step 4 of 'Installing the Dome Camera'
Ceiling Mount Ceiling Mo Ceiling Mo Ceiling Mo unt - Microphone should be situated facing back of bus unt unt
Bulkhead Mount Bulkhead Mount - Microphone should be situated facing floor.
Bulkhead Bulkhead Mount Mount
Use the FRONT label as your guide. Ensure the Lens/Microphone
assembly is located directly above the FRONT label.
Camera Gasket
-17-
Figure 10 Figure 10: Removing Outer and Polycarbonate Dome. : Removing Outer and Polycarbonate Dome.
Figure Figure 10 10 : Removing Outer and Polycarbonate Dome. : Removing Outer and Polycarbonate Dome.
Figure 11 Figure
Figure Figure
Figure 12 Figure Figure Figure
11: Camera Seat Position. : Camera Seat Position.
11 11 : Camera Seat Position. : Camera Seat Position.
12: Mounting the Camera 12 12 : Mounting the Camera. . . . : Mounting the Camera : Mounting the Camera