Installation; Ten Steps For Installers; Recommended System Locations; Figure 7: Recommended System Locations - Gatekeeper Systems Digital Smart Recorder NiTRO 900 Manual

Ensure the NiTRO™ system is off while inserting the comrad™

Installation

Installation. . . . Installation Installation
Always refer to your applicable Vehicle Safety Regulations before mounting any
hardware.

Ten Steps for Installers

Ten Steps for Installers. . . .
Ten Steps Ten Steps for Installers for Installers
Locate a site for the NiTRO™ System
Locate a site for the camera(s)
Locate a site for the GPS Antenna (optional)
Locate a site for the IR Illuminator (optional)
Locate site for all other accessories, ie. Alarm Button, Record LED (optional)
Mount the Isolation Suspension System plate
Run Power harness through enclosure to destination
Connect the constant power on the power harness to the Bus battery
Run the camera harness(es) to the camera destination(s)
Run the Sensor harness to the destination
Installers should refer to the individual product installation sheets that are included
for each part listed below:
Camera(s)
GPS
All Accessories
Recommended

Recommended System Locations

System Locations. . . .
Recommended Recommended System Locations System Locations
Inside or on
Bulkhead
Driver's Console
Behind Driver's Seat
Figure Figure 7 7 7 7 : Recommended System : Recommended System L L L L ocations
Figure Figure : Recommended System : Recommended System
Power Harness
Camera Harness(es)
ocations. . . .
ocations ocations
Inside Glove Box or
Under Dash Board
Behind Modesty Panel
-13-