Gatekeeper Systems Digital Smart Recorder NiTRO 900 Manual page 25

STARTUP MODE
PURPOSE: PURPOSE: The startup mode defines the state the recorder will be in when it has been turned on. PURPOSE: PURPOSE:
ENTRY: Use the plus and minus signs to scroll ENTRY
ENTRY ENTRY
through the three options.
OTHER OTHER:
OTHER OTHER
Record: the recorder will automatically
start recording – if record delay is set
to a value other than no delay then it
will wait the delay time before starting
to record.
Playback:
the
automatically
menu and a video playback window on
the video monitor.
Standby: the recorder will stay on the
configuration screen, awaiting some
type of action upon startup.
SET UNITS
PURPOSE PURPOSE: The set units menu relates to units of measured speed. There are two options for the units to be used. The two
PURPOSE PURPOSE
choices are US US or Metric US US Metric. If US units are chosen, the mph (miles per hour) will be displayed for the measurement of speed. Metric Metric
If metric is chosen, then the units are kph (kilometers per hour).
ENTRY ENTRY: Use the plus and minus signs to toggle ENTRY ENTRY
between the two options.
CALIBRATE TEST
PURPOSE: If the recorder is wired to monitor the speed of the vehicle, the units need to be calibrated to the speedometer. PURPOSE
PURPOSE PURPOSE
When the units are calibrated, the speedometer reading will appear on the LCD screen and in the subtitles. If no
speedometer is hooked up, then speed will not be displayed on the screen. Calibration does not need to be done if you are speedometer is hooked up, then speed will not be displayed on the screen.
speedometer is hooked up, then speed will not be displayed on the screen. speedometer is hooked up, then speed will not be displayed on the screen.
using GPS for speed readings.
ENTRY ENTRY ENTRY: Press 'Go' to enter the calibrate menu. ENTRY
Press start to begin calibration and
start driving one measured mile or km.
Press Done after traversing one mile
(or km) or Cancel to stop in the middle
of calibration and return to the
Calibrate menu.
Calibration is complete when Done is
pressed; the pulses per unit are shown.
OTHER OTHER OTHER OTHER: Whatever units were chosen in the Set
Units menu will be displayed under the
calibration. After calibration is complete, the
number of pulses is automatically displayed in
Example: To calibrate the
the Set Pulses menu.
recorder for a vehicle traveling in miles per
hour:Press "Start" in the Calibrate Test menu on
recorder will
display the playback
EXIT: Use the right arrow to advance to the next menu or left arrow to EXIT
EXIT EXIT
advance to the previous menu. Press the blue menu button to exit and
return to the Advanced sub menu.
EXIT EXIT EXIT EXIT: Use the right arrow to advance to the next menu or left arrow to
advance to the previous menu. Press the blue menu button to exit and
return to the Advanced sub menu.
EXIT: Press the blue menu button to exit and return to the Calibrate EXIT EXIT EXIT
Test menu.
-25-
DEFAULT CONDITION: Record DEFAULT CONDITION
DEFAULT CONDITION DEFAULT CONDITION
DEFAULT CONDITION: US DEFAULT CONDITION DEFAULT CONDITION DEFAULT CONDITION
. If no
. If no . If no
DEFAULT CONDITION: N/A DEFAULT CONDITION DEFAULT CONDITION DEFAULT CONDITION