Specific Safety Instructions For The Control Module Delta - ProMinent delta Operating Instructions Manual

2.2

Specific safety instructions for the control module delta

NOTICE!
Correct sensor operation / Run-in time
Damage to the product or its surroundings
– Correct measuring and dosing is only possible if
the sensor is working perfectly
– It is imperative that the run-in times of the sensors
are adhered to
– The run-in times should be allowed for when plan‐
ning initial operation
– It may take a whole working day to run-in the
sensor
– Please read the operating instructions for the
sensor
NOTICE!
Correct sensor operation
Damage to the product or its surroundings
– Correct measuring and dosing is only possible if
the sensor is working perfectly
– Check and calibrate the sensor regularly
NOTICE!
Compensation of control deviations
Damage to the product or its surroundings
– This controller cannot be used in control circuits
which require rapid compensation (< 30 s)
WARNING!
Emergency stop switch
Possible consequence: Fatal or very serious injuries
An emergency stop switch on the complete system.
This should enable the complete system to be
switched off in event of an emergency in such a way
that the complete system is stopped in a safe condi‐
tion.
WARNING!
– Hazardous substances
– Danger resulting from contact, breathing in or other
contaminations with / from substances or media
– Observe the safety data sheet of the substances /
media used
– The system operator must ensure that these safety
data sheets are available and that they are kept up
to date
Safety and responsibility
®
9