Factory Settings Of The Control Module Delta - ProMinent delta Operating Instructions Manual

Operating Schematics / Display Symbols
T T
N V
0 0
>0 0
0 >0
>0 >0
Sensor Parameter
Chlorine Set point
X
p
T
N
T
V
pH Set point
X
p
T
N
T
V
Redox Set point
X
p
T
N
T
V
6.11

Factory settings of the control module delta

32
Controllers
P controller
PI controller
PD controller
PID controller
Comment
0.01 ppm to the upper limit of the measuring range. In increments of 0.01
ppm. Start value: 50 % of the measuring range
0 to measuring range in increments of 0.01 ppm. Start value: 10 % of the
measuring range
0 s to 9999 s in increments of 1s. Start value 0 s.
0 s to 9999 s in increments of 1s. Start value 0 s.
pH 0,01 pH to 14 pH in increments of 0.01 pH. Start value 50 % of meas‐
uring range
0 pH to measuring range in increments of 0.01 pH. Start value: 10 % of the
measuring range
0 s to 9999 s in increments of 1s. Start value 0 s.
0 s to 9999 s in increments of 1s. Start value 0 s.
0 mV to 1,000 mV in increments of 1 mV. Start value: 50 % of the meas‐
uring range
0 mV to 1,000 mV in increments of 1 mV. Start value: 10 % of the meas‐
uring range
0 s to 9999 s in increments of 1s. Start value 0 s.
0 s to 9999 s in increments of 1s. Start value 0 s.
The factory settings that are loaded always refer to the current
sensor used (pH, Redox or chlorine).
If the request is acknowledged with
for the characteristic curve data, measurement range, set value
and control parameters can be loaded.
Default values for the characteristic curve data
As the parameters for the characteristic curve are
default values, the sensors must be calibrated.
®
„yes" , then the default values