Setting The "Two-Pump Mode - ProMinent delta Operating Instructions Manual

Operating Schematics / Display Symbols
6.12

Setting the "Two-pump mode"

Main
Operation
proControl
Set
Clear
Controller
Check out time
Hardware calib.
Reg. work set
2nd pump
Fig. 18: Setting the "Two-pump mode"
Settings Comment
Activating
The controller is only active when the control relay in the delta
has been activated.
Strokes / min. Stroke rate of the pump in strokes / minute. maximum 180 / min.
Volume Volumes in litre / hour
34
The control module delta
mode. Different parameters have to be entered for both pumps for
this purpose.
Set
Sensor calibr.
Controller
Concentration
Aux.
2. Pump
Activate
Strokes/min: 120
Volumes : 25.0 l/h
2. Pump
Activate
Strokes/min: [120]
Volumes : 25.0 l/h
2. Pump
Activate
Strokes/min: 120
Volumes : [25.0 l/h]
The control module delta
via the relay output of the delta
can also be operated in two-pump
®
Activate
yes
no
Activate
yes
no
® now controls the second pump indirectly
solenoid metering pump.
®
solenoid metering pump
®
A0324