Secondary Display Extended Control Module Delta; Activating / Deactivating The Control Module Delta - ProMinent delta Operating Instructions Manual

6.3

Secondary display extended control module delta

6.4

Activating / deactivating the control module delta

Main
Operation
proControl
Set
Clear
Fig. 10: Activating / deactivating the control module delta
Operating Schematics / Display Symbols
In the secondary display, the specified nominal value as well as the
current actual value of the control module delta
I. Setpoint (of the control module delta
n
(8 x 8 points), in the selected unit (ppm, pH or mV)
[i] (input value of the control module delta
II. Actual value
n
very large figure (8 x 8 points), in the selected unit (ppm, pH or
mV)
III. Current value (input value of the control module delta
n
xx,xx mA
IV. Existing continuous display on the
n
delta ® solenoid metering pump
Format for the secondary display (S = Setpoint):
Chlorine: (S) XXX.YY ppm
n
pH: (S) XX.YY pH
n
Redox: (S) XXX mV
n
Display: Only measured value = actual value
Display: Measured value with an
This menu is available for putting the delta
pump in the operating mode for the control module delta
proControl
Inactive
P
Active
proControl
Inactive
Active
®
If the control module delta
controlling of the delta ® solenoid metering pump takes place in the
control module delta ® . Independent as to which operating mode
the delta solenoid metering pump was previously located. If the
®
control module delta ® is set to
metering pump returns back to its original operating mode.
In the inactive state, no error messages or warning messages are
transferred to the delta solenoid metering pump.
®
If the control module delta
appears in the operating indicator of the delta
metering pump to indicate that the control module delta
actively. At the same time, the light diode
LED" switches to green with regular operation.
®
can be displayed.
®
® ) in a very large figure
„S" in front of it = Setpoint
®
® solenoid metering
P
P
„active" , then operation or
is set to
®
„inactive" , then the delta
„active" then the symbol
® is set to
solenoid
®
„Connecting
) in a
®
® ) in
.
®
A0312
® solenoid
® is working
25