Setting The Set Value; Setting The Checkout Time - ProMinent delta Operating Instructions Manual

6.8

Setting the set value

Main
Operation
proControl
Set
Clear
Controller
Setpoint
Parameter
Basic load
Limit value
Fig. 14: Setting the set value
Setting
Display Starting value
mV 500 mV
pH 7.00 pH
Chlorine 5.00 ppm
The upper and lower value can only be adjusted in the scope of the adjusted limit values, see
6.6 „Setting the limit values" on page 27 . The values in the table shows the maximum possible range.
6.9

Setting the checkout time

Main
Operation
proControl
Set
Clear
Controller
Parameter
Basic load
Limit value
Check out time
Fig. 15: Setting the checkout time
You can set the set value via this menu. An
display value for the set value is displayed in the continuous
display.
Set
Sensor calibr.
Controller
Concentration
Aux.
Setpoint
[ 500 ] mV
Possible values
Increment Lower value
1 mV 0 mV
0.01 pH 0.00 pH
0.01 ppm 0 ppm
Monitoring of the controlled system
The checkout time monitors the controlled system.
Possible defective sensors may be detected via the
mechanism of the checkout time.
Set
Sensor calibr.
Controller
Concentration
Aux.
Check out time
[120] min
Operating Schematics / Display Symbols
„S" is put in front in the
Upper value Remarks
999 mV Redox
14.00 pH
20 ppm
A0363
Ä Chapter
A0315
29