Setting The Controller Pulse Of The Second Pump - ProMinent delta Operating Instructions Manual

6.12.1

Setting the controller pulse of the second pump

Main
Operation
proControl
Set
Clear
Relay
Relay 1
Relay 2
Fig. 19: Menu for adjusting the controller pulse of the second pump
Operating Schematics / Display Symbols
NOTICE!
Calibrating the delta
To enable the second pump to be controlled by the
delta solenoid metering pump, the
®
delta ® solenoid metering pump must have been cali‐
brated. Notes for this purpose: Operating instructions
"Solenoid metering pump delta
noid drive optoDrive
function "Calibration" (CALIBRATION menu)"
Depending on the pump type that should be connected to the
control relay of the delta ®
to set the controller pulse accordingly. The controller pulse can be
a growing or a falling pulse of the controller relay. Take note that
this menu can only be called up when a control relay has been
installed in the delta solenoid metering pump.
®
Set
Calibrate
Metering
Relay
System
Relay 2
Warning
Warning+error
Pulse
Option
Relay 2
[100] ➽/min at 100 %
solenoid metering pump
®
® with controlled sole‐
„Settings for the
® ", chapter
solenoid metering pump, it is necessary
A0319
35