Assembly; Installation (Hydraulic) - ProMinent delta Operating Instructions Manual

Assembly

4 Assembly
4.1

Installation (hydraulic)

18
NOTICE!
Installation position and conditions
– Ensure that there is unimpeded access for opera‐
tion
– Secure, low-vibration fixing
– Avoid direct sunlight
– Permissible ambient temperature at fixing position:
-10 ... + 45 ℃ at max. 95% relative air humidity
(non-condensing)
NOTICE!
Operating instruction for all components used
Possibility of material damage due to incorrect
assembly.
When assembling the system, observe the operating
instructions for all components used.
Reading and operating position
Install the device at a favourable position for
–
reading and operating (preferably at eye level)
The control module delta
metering pump and must not be installed separately.
CAUTION!
– Observe the maximum permissible operating
parameter for the entire installation of the meas‐
uring / control station (e.g. pressure, temperature,
flow)
– In the process, observe the lowest maximum
permissible operating parameter of the parts of the
measuring / control and the sensors installed (see
their operating instructions)
– Please also observe the operating instructions for
controllers and fittings and any other component
groups, such as sensors, sample water pumps ...
– Observe the flow direction of the measured water.
– One pressure reducer must be installed.
– Danger resulting from media under pressure.
– Before working with hydraulic parts of the meas‐
uring / control station, this must be depressurised
in a controlled manner via the sampling cock.
– Wear protective goggles
Fittings
is fully integrated in the delta
®
solenoid
®