Accu-Scope EXI-410 Series Manual page 18

EXI-410 INVERTED MICROSCOPE SERIES
Power Cord
VOLTAGE CHECK
Confirm that the input voltage indicated on the rear label of the microscope corresponds to your line
voltage. The use of a different input voltage than indicated will cause severe damage to your
microscope.
Connecting the Power Cord
Make sure the On/Off Switch is "O" (the off position) before connecting the power cord.
Insert the power plug into the power outlet of the microscope; make sure the connection is snug.
Plug the power cord into a power supply receptacle.
NOTE: Always use the power cord that came with your microscope. If your power cord becomes
damaged or lost, please call your authorized ACCU-SCOPE dealer for a replacement.
ACCU-SCOPE ®
73 Mall Drive, Commack, NY 11725 • 631-864-1000 • www.accu-scope.com 17