Table of Contents
Advertisement
German Light Products
● Pan, tilt, and zoom modes: N (Normal) or I (inverse)
● Dimming curve: L (Linear) or S (Soft)
● Lamp power mode: ECO will be displayed if the ECO (1000 W) mode is enabled.
There is no lamp power indication if the lamp is in Normal (1400 W) mode.
● Fixture's DMX address
● Protocol type: DMX, Art-Net, sACN or CRMX (if an optional CRMX module is installed)
In the example shown in Figure 3:
● The fixture is running CPU software version 26
● Pan, Tilt and Zoom are set to Normal
● The dimmer is set to Soft dimming curve
● Lamp power is set to 1000 W (ECO)
● The fixture is set to receive data via DMX protocol
● The fixture's DMX start address is 101.
Using the control panel
From the default screen you have three options:
● Pressing the ENTER button under Menu on the right opens the main menu for
configuration, service and information.
● Pressing the BACK/ESC button on the left under Shortcut opens the quick menu with
the most frequently used settings.
● Pressing both buttons quickly at the same time flips the display.
Once you have opened the main menu or the quick menu, navigate and apply
commands as follows:
● Use the jog wheel to scroll up and down through menu items
● Use the ENTER button on the right to enter a submenu or confirm a selection.
● Use the BACK/ESC button on the left to exit a menu. If you have not confirmed a
selection with the ENTER button, no command will be applied.
Fixture overview
If you rotate the jog wheel a half-turn while the default screen is being displayed, the
display will change to a general fixture overview which gives you quick information
about software version, lamp hours, fixture settings etc. This feature is very helpful for
maintenance or service tasks.
Error codes
If the fixture detects an error it will display an error code in place of the DMX address. All
error codes except the HOT message (lamp hot, restrike impossible until lamp has
cooled down) are sticky: they will remain in the display until the next power cycle or
motor reset.
'Status and error codes' on page 24 gives a key to all the codes in the Highlander Wash.
Hilghlander Wash User Manual
®
13
Advertisement
Table of Contents
