Table of Contents
Advertisement
German Light Products
Pan
Pan Fine
Tilt
Tilt fine
... scroll through effects
...
Manual DMX
Load No-Signal Scene
Warning!
Fixture will
start moving!
Save as No-Signal Scene
Press Enter
Capture DMX Values
Reset Manual Values
Service
Test All
Test
Sequences
Test Pan / Tilt Only
Test Head Only
Device Hours
Reset
Counters
Lamp Counters
Service
On/Off
Mode
Offsets
Clear FW Image
Reprogram Slaves
Save Settings
Advanced
(Press and
hold for 3
secs.)
Factory Backup (!)
Enter Factory Mode
Default settings are written in BOLD type
Hilghlander Wash User Manual
®
< 001..128..255 >
< 001..128..255 >
< 001..128..255 >
< 001..128..255 >
Confirm (press Enter)
Confirm (press Enter)
Confirm (press Enter)
Confirm (press Enter)
Pan
...
...
Yes/No
Yes/No
Preset 1
Preset 2
Preset 3
Yes/No
Yes/No
Manually control all
effects (Framing always in
P/I mode)
Display the scene that is
stored as Captured Scene
Capture current scene
and store it as Captured
Scene for use in No Signal
menu
Sets all manual DMX
values to the values
currently being received
via DMX
Reset all manually entered
DMX values to zero
Run test sequence of all
effects including pan and
tilt
Run test sequence of pan
and tilt only
Run test sequence of all
effects except pan and tilt
Zero the resettable fixture
on-time hours counter
Zero the resettable lamp
strikes and lamp-on hours
counters
Enable/disable pan and
tilt
Create custom offsets in
home positions of all
effects. Default offset = 0
Clear firmware file from
memory
Install firmware from
image file in all slaves
Saves current fixture
settings as custom presets
for use in Fixture Settings
Load Settings
Restore all factory default
settings (including DMX
address, protocol type,
Ethernet / CRMX
configuration, user offsets
and user presets) – hold
for 5 secs.
Contact GLP Service
before entering this menu
– changes can cause
damage to the fixture that
is not covered by the
product warranty
19
Advertisement
Table of Contents
