Comestero Suzohapp Multi PRO Operating Manual page 35

Multi PRO – Operating Manual
This board has: 8 output terminals (Cn2 to Cn16), 8 input terminals (a to h) and one input for
the 24 VDC ± 20% low voltage power supply.
Connect the MaxiBio board to the equipment as shown.
Connect the input and output signals to the MaxiBio board referring to the diagrams below
and in the following page.
Each output terminal has 3 contacts (relays): a normally open one on the right (NO), a
common one in the centre (C) and a normally closed one on the left (NC).
For output configuration, please refer to the "MaxiBio outputs" section in the "Devices"
paragraph, further below in this manual.
For input configuration, please refer to the "MaxiBio inputs" section in the "Devices"
paragraph, further below in this manual.
35