Connections; Connection To Power Supply - Comestero Suzohapp Multi PRO Operating Manual

7

Connections

7.1 Connection to power supply

For the installation, always refer to the specific standards on protection against electric
contacts.
All the electrical connections of the machine have been installed, except
for the power supply. Before connecting the machine to the mains,
make sure that the main switch, located at the bottom left on its inner
wall, is turned to "0" (Figure 19).
Check that the power socket to which the machine is going to be
connected has an appropriate electrical rating, complying with that of
the machine, and that it is protected by a residual current device with a
rated residual operating current <=30mA.
This switch must ensure the disconnection from the mains with a
contact opening distance allowing for full disconnection under the
conditions set out for overvoltage category III
The mains disconnector in question must be easily accessible.
USE A SELF-EXTINGUISHING CABLE
Figure 19
32
EN