Mitsubishi Electric MELSENSOR MELSEC iQ-R MH11H01A0SNA User Manual page 52

MH11H35C3SNA, MH11H35C3LNA
Item
*1
Measurement method
Measurement center distance
*2
Measurement range
Beam source
*3
Beam diameter
Light receiving element
Resolution
Linearity
Temperature characteristics
Safety distance (Normal ocular hazard
*5
distance: NOHD)
Indicator Laser radiation
indicator
Measurement range
indicator
Protective structure
Pollution degree
Insulation resistance
Withstand Commercial
voltage frequency
Impulse
Vibration resistance
Shock resistance
Ambient illuminance
Operating ambient temperature
Operating ambient humidity
Operating altitude
Material
Cable length
Cable extension
Weight
For measuring conditions not specified, refer to the following.
Page 39 Product specification notes
*1 Use the ND filter in case the amount of reflected beam is too large.
*2 The measurement range is limited between -70 and 200mm (in case the sampling cycle is 20s), or between 100 and 200mm (in case
the sampling cycle is 10s).
*3 The figure shows the value at measurement center distance. It is determined by 1/e
Due to leak light outside the specified area, the reflectance around the detecting point may be higher than at the point and this may
affect the measurement value.
*4 The variation in ambient illuminance is 0.08% F.S. or less.
*5 Terminate a laser beam using a diffusely reflecting material or by an absorber regardless of the safety distance.
2 SPECIFICATIONS
50
2.2 Sensor Head Specifications
MH11H35C3SNA
Diffuse reflection
350mm
200mm
Red semiconductor laser, Class 3R (JIS/IEC/GB/FDA)
Max output: 5mW, Emission peak wavelength: 658nm
Approx. 400m
Linear image sensor
8m/average times: 256, 2m/average times: 4096
0.04%F.S. (-200 to 0mm), 0.08%F.S. (0 to 200mm) (F.S. = 200mm)
0.01% F.S./
1.4m
Green light-emitting diode
ON during laser radiation
Yellow light-emitting diode
ON near the measurement center/Flashes within the measurement range/OFF outside the measurement range
IP67 (excluding the connector part)
2
With 500VDC megger, 20M or more (between all the terminals and case)
500VAC, 1 minute (between all the terminals and case)
1000V, 1.2/50s (between all the terminals and case)
Endurance: 10 to 55Hz (cycle: 1 minute), double amplitude: 1.5mm
X, Y, Z directions, 2 hours each
196m/
X, Y, Z directions, 3 times each
*4
3000lx or less (illuminance at light receiving surface using incandescent lamp)
0 to 45 (No dew condensation or icing allowed)
At storage: -20 to 70
35 to 85%RH
At storage: 35 to 85%RH
0 to 2000m
Main body case, main body cover: Die-cast aluminum
Front cover: Glass
0.5m
The cable length can be extended to full length of 30m with the extension cable for sensor head.
Approx. 300g (including the sensor head cable)
MH11H35C3LNA
Approx. 400  6500m
2
(approximately 13.5%) of center beam intensity.