Chain Lubrication - Titan TTK587GD0 Safety And Operating Manual

CHAIN LUBRICATION

Filling Chain Oil
WARNING! The product is not filled with chain oil. It is essential to fill the product
with chain oil before using it! Never operate the product without chain oil as this will
result in extensive damage to the product!!
Operating the saw chain dry or with too little chain oil will decrease cutting efficiency,
shorten the product life span and cause rapid wear to the saw chain and guide bar
from overheating! Insufficient chain oil is evident by smoke or bar discoloration!
Adequate lubrication of the saw chain during cutting operations is essential to
minimise friction with the guide bar!
1. Set the product on any suitable surface with the chain oil tank cap (D1) facing upwards.
(See Fig. 13a)
2. Unscrew and remove the tank cap (D1), then add the lubricant into the tank. We recommend
using environmentally-friendly chain oil specifically intended to be used with this product.
3. Use a proper funnel with a filter to prevent debris entering the tank and to avoid spilling and
overfilling the tank. Do not overfill and leave approximately 5 mm of space to the lower edge
to allow the lubricant to expand. (See Fig. 13b)
4. Wipe up spilled fuel with a soft cloth and refit the chain oil tank cap (D1).
NOTE: Always dispose of lubricant, used oil and objects contaminated with them in accordance
with local regulations.
Checking Chain Oil
Check the chain lubrication before each use.
NOTE: This product is equipped with an automatic oiling system! The oiling system
automatically delivers the proper amount of oil to the bar and chain! Checking the
lubrication requires starting the engine. Before checking the product must be fully
assembled and all instructions must have been read.
25CC PETROL MULTI TOOL TTK587GDO
Fig. 13a
Fig. 13b
31