Titan TTK587GD0 Safety And Operating Manual page 8

WARNING! Always switch the product off and disconnect the spark plug connector
before adjusting the saw chain tension!
The cutting edges of the saw chain are sharp. Always wear protective gloves when
handling the chain!
Always maintain proper chain tension! A loose chain increases the risk of kickback! A
loose chain may jump out of the guide bar groove! This may injure the operator and
damage the chain! A loose chain will cause rapid wear to the chain, guide bar and
sprocket!
Tensioning the chain too tightly will overload the engine and cause damage, and
insufficient tension can cause chain derailing, whereas a correctly tightened chain
provides the best cutting characteristics and prolonged working life! The chain life
mainly depends upon sufficient lubrication and correct tensioning!
1. Loosen the locking nut. Lift the tip of the guide bar (D7) and keep it there as you adjust the
tension.
2. Turn the tension screw (D12) clockwise until the chain "tie straps" are just touching the
bottom edge of the guide bar (D7). (See Fig. 11)
3. Check the chain tension using one hand to lift the saw chain (D6) against the weight of the
product. The correct chain tension is achieved when the saw chain can be lifted by approx.
2-4mm from the guide bar (D7) in the centre. (See Fig. 12a, 12b)
4. Turn the locking nut (D3) to tighten the cover (D2) completely.
30
25CC PETROL MULTI TOOL TTK587GDO
D12
Fig. 11
Fig. 12a
D7
Fig. 12b
D6