Titan TTK587GD0 Safety And Operating Manual page 19

WARNING! After changing the trimming line, run the product under no load for at
least a minute to make sure that the line and the product are operating correctly!
WARNING! Never use steel thread! Always use cutting means in perfect condition,
free of damage!
Blade (Hedge Trimmer)
1. Keep the hedging blade (C1) clean and free of debris. Remove trimmings.
2. Keep the hedging blade (C1) sharp to retain a good cutting performance. Replace a worn
or damaged cutting blade with a new one of the same type.
3. Lubricate the hedging blade (C1) after each use to prolong the life span of cutting blade
and product. Apply light machine oil along the edge of the cutting blade.
Guide Bar and Saw Chain Maintenance
Replace chain and guide bar
1. Use only the guide bar (D7) and saw chain (D6) according to the technical data of the
product.
WARNING! Always use a saw chain designed as "low-kickback" or a saw chain
which meets the low-kickback requirements! A standard saw chain (a chain which
does not have the kickback reducing guard links) should only be used by an
experienced professional operator! Nevertheless, a low-kickback saw chain does
not completely eliminated kickback! A low-kickback or "safety" chain should never be
regarded as complete protection against injury!
2. Place the product on a suitable flat surface with the cover (D2) facing upwards.
3. Loosen locking nut (D3) with the socket wrench (E6) anticlockwise and remove it
together with the spring washer (D4) and cover (D2). (See Fig. 35a, 35b)
4. Turn the tension screw (D12) clockwise with the slotted screwdriver (E6).and make sure
the tension pin(D11) is adjusted to its closer position. (See Fig. 35c)
25CC PETROL MULTI TOOL TTK587GDO
Fig. 35a
Fig. 35c
Fig. 35b
49