Titan TTK587GD0 Safety And Operating Manual page 13

WARNING! Make sure that the cutting blade is not touching the ground or other
objects when starting the product!
5. Allow the product to run at idle speed for 10 to 15 seconds to let it warm up; move the choke
lever (A3) to its "
6. Once the engine is running correctly, carefully lift the product and securely hold it by its
handles
NOTE: During idle running the cutting blade should not move. Contact a qualified technician if
you find that the cutting blade is moving.
Warm start
1. Place the product on a flat, stable surface. Ensure that the attachment in use does not
touch the ground or any objects.
2. Set the ignition switch (A19) to its on position "I". (See Fig. 21a)
3. Move the choke lever (A3) to the "
4. Hold the product stable and pull the recoil starter handle (A7) firmly; repeat until the engine
starts. Allow the recoil starter rope to return slowly and controlled after each pull! (See Fig.
21c)
36
25CC PETROL MULTI TOOL TTK587GDO
" position once the engine is warm.
"position, do not press the primer. (See Fig. 21b)
Fig. 21a
Fig. 21b
Fig. 21c