Titan TTK587GD0 Safety And Operating Manual page 40

Fig. 20a
Fig. 20b
SPARK PLUG
NOTE! This engine uses a CHAMPION RCJ6Y spark plug
A2
with 0.6-0.7mm electrode gaps. Use a suitable
replacement and replace once a year. You can it replace
with "CHAMPION" or "NGK" as an alternative.
1. Inspect the spark plug at least every 25 hours or prior
to long-term storage over 30 days if the use has not been
this high. Clean or replace with a new spark plug if
necessary.
2. Unplug the spark plug connector (A2). Loosen the
spark plug with the spark plug wrench (D2, D1)
anticlockwise and carefully remove it. (See Fig. 20a)
3. Check the spark plug for damage and wear. The colour
of the electrode should be light-brown coloured.
4. Remove debris from the electrode with a soft wired
brush; avoid heavy cleaning of the electrode.
5. Dry the spark plug with a soft cloth if it is wet from fuel.
6. Check the spark plug gap; it should be 0.6 - 0.7 mm.
(See Fig. 20b)
7. Replace with a new spark plug if either the electrode or
the insulation is damaged.
8. When replacing the spark plug, first screw it in hand
tight and then lightly tighten it with the spark plug wrench.
WARNING! Do not over-tighten the spark plug to
avoid any damage!
BEVEL GEAR(HEDGE TRIMMER)
The bevel gear is filled with grease. Ask an authorised
service centre or similar qualified person to check the
quantity regularly and fill up using proper grease if
necessary.
CARBURETTOR
The carburettor is pre-set by the manufacturer. Should it
be necessary to make any changes please contact an
authorised service centre or a similarly qualified person.
Do not attempt to make any adjustments by yourself.
REPAIR
This product does not contain any parts that can be
repaired by the consumer. Contact a qualified specialist
to have it checked and repaired.
STORAGE
1. Clean the product as described above.
2. Store the product and its accessories in a dry, frost-
free, well-ventilated place.
3. Always store the product in a place that is inaccessible
to children. The ideal storage temperature is between 10
and 30°C.
4. We recommend using the original package for storage
or covering the product with a proper cloth or enclosure
to protect it against dust.