Danfoss VLT Micro Drive FC 51 Series Programming Manual page 57

4. Parameter Descriptions
[6] AutoReset 6
[7] AutoReset 7
[8] AutoReset 8
[9] AutoReset 9
[10] AutoReset 10
[11] AutoReset 15
[12] AutoReset 20
[13] Infinite auto reset
4
14-21 Automatic Restart Time
Range:
*
10 s [0 - 600 s]
14-22 Operation Mode
Option:
Normal Operation
*
[0]
[2] Initialization
4.11.5. 14-4* Energy Optimizing
These parameters are for adjusting the energy optimization level in both Variable Torque (VT) and Automatic Energy Optimization (AEO) modes.
14-41 AEOMinimum Magnetization
Range:
*
66% [40 - 75%]
56
Performs six automatic resets after tripping.
Performs seven automatic resets after tripping.
Performs eight automatic resets after tripping.
Performs nine automatic resets after tripping.
Performs ten automatic resets after tripping.
Performs fifteen automatic resets after tripping.
Performs twenty automatic resets after tripping.
Performs an infinite number of automatic resets after tripping.
Motor may start without warning.
Function:
Enter time interval from trip to start of automatic reset function. This parameter is active when par. 14-20,
Mode Automatic Reset
, is set to [1] - [13].
Function:
Use this parameter for specifying normal operation or to initialize all parameters, except par. 15-03, 15-04 and
15-05.
Frequency converter runs normal operation.
Resets all parameters to default settings, except for 15-03, 15-04 and 15-05. Frequency converter resets during
next power-up.
Par. 14-22 also reverts to default setting
Function:
Enter the minimum allowable magnetization for AEO. Selecting a low value reduces energy loss in the motor, but
may also reduce resistance to sudden load changes.
MG.02.C4.02 - VLT is a registered Danfoss trademark
VLT Micro Drive FC 51
Normal Operation
[0].
Reset