Danfoss VLT Micro Drive FC 51 Series Programming Manual page 15

4. Parameter Descriptions
* No Copy
[0 ]
[1] Copy from Set-up 1
[2] Copy from Set-up 2
[9] Copy from Factory Set-
up
4
4.1.6. 0-6* Password
0-60 (Main) Menu Password
Range:
*
0 [0 - 999]
NB!
A password only has affect on the LCP - not on the bus communication.
NB!
Pressing buttons [MENU], [OK] and down will unlock the password. This will automatically enter the parameter editing screen in Quick
Menu or Main Menu.
14
NB!
The keyboard/parameter database are blocked while Set-up Copy is running.
Copy function is inactive
Set-up 1
Copy from to edit set-up chosen in par. 0-11,
Copy from Set-up 2 to edit set-up chosen in par. 0-11,
Copy from Factory Settings to edit set-up chosen in par. 0-11,
Function:
Use password for protection against unintended change of sensitive parameters, eg. motor parameters.
Password protected parameters can always be read, but cannot be edited without entering the password.
Enter the password for access to Main Menu via the [Main Menu] key. Select the number that should allow for
0
changing other parameter values. means there is no password.
MG.02.C4.02 - VLT is a registered Danfoss trademark
VLT Micro Drive FC 51
Edit Set-up
.
Edit Set-up .
Edit set-up .