Henny Penny 600 Service Manual page 59

2 2 . . 1 1 6 6 . . 6 6 T T i i m m e e r r S S w w i i t t c c h h
Connect light leads to terminal board of timer.
1 1 ) )
Remove switch nuts and remove switch from panel.
2 2 ) )
Disconnect switch wires from terminal board.
3 3 ) )
Install new switch on panel and secure with switch nut.
4 4 ) )
Connect switch wires to the terminal board of timer.
5 5 ) )
2 2 . . 1 1 7 7 P P r r e e s s s s u u r r e e R R e e g g u u l l a a t t i i o o n n / / E E x x h h a a u u s s t t
T T o o a a v v o o i i d d e e l l e e c c t t r r i i c c a a l l s s h h o o c c k k o o r r p p r r o o p p e e r r t t y y d d a a m m a a g g e e , , m m o o v v e e t t h h e e
p p o o w w e e r r s s w w i i t t c c h h t t o o o o f f f f a a n n d d d d i i s s c c o o n n n n e e c c t t m m a a i i n n c c i i r r c c u u i i t t b b r r e e a a k k e e r r , , o o r r
u u n n p p l l u u g g c c o o r r d d a a t t w w a a l l l l r r e e c c e e p p t t a a c c l l e e . .
2 2 . . 1 1 7 7 . . 1 1 S S o o l l e e n n o o i i d d V V a a l l v v e e
This is an electromechanical device that causes pressure to be held in the vat (frypot).
The solenoid valve closes at the beginning of the cook cycle and is opened
automatically by the timer at the end of the cook cycle. If this valve should become
dirty or the Teflon seat nicked, pressure will not build up. The fryer uses a 120 volt, 60
Hz, coil.
2 2 . . 1 1 7 7 . . 2 2 C C o o i i l l C C h h e e c c k k P P r r o o c c e e d d u u r r e e
Remove wires from terminals 73 and 72 and check across solenoid wires.
1 1 ) )
45