Henny Penny 600 Service Manual page 29

Reconnect the connectors on the back of the control.
3 3 ) )
2 2 . . 4 4 . . 3 3 C C o o n n f f i i g g u u r r e e t t h h e e S S e e r r i i a a l l N N u u m m b b e e r r
NOTICE : The serial number must be added correctly in to the control or the WiFi
module cannot receive or transmit data, including automated software updates.
2 2 . . 4 4 . . 3 3 . . 1 1 V V e e r r i i f f y y t t h h e e S S e e r r i i a a l l N N u u m m b b e e r r
Set the power switch to the OFF position.
1 1 ) )
Locate the machine data plate on the inside of the filter pan door, and then
2 2 ) )
record the serial number displayed on it.
N N O O T T E E : Serial numbers may be one of two formats:
• AAXXXXXXX (AA followed by seven digits)
• BCXXXDE (Two letters followed by three digits followed by two more letters)
The serial number may also be etched in to the rear top left corner of the pot
(see image below).
Press and hold
3 3 ) )
ENTER CODE displays.
Press twice. SETUP / ENTER CODE displays.
4 4 ) )
Using the left product buttons, press 1,2,3. - SETUP MODE - briefly displays.
5 5 ) )
Compare the serial number displayed in SM-1 with the number you recorded.
6 6 ) )
Perform one of the two actions:
7 7 ) )
•
If the serial number matches, press and hold
control resumes normal operation.
•
If the serial number is missing or does not match, follow either the 9 or 7
character serial number correction procedure.
for 7-8 seconds until L-2 LEVEL 2 displays. CFA PROG /
until - OFF - displays. The
15