Chapter 8 Annual Inspection - Henny Penny 600 Service Manual

Remove the deadweight cap.
1 1 ) )
Inspect and replace the cap's O-ring if necessary.
2 2 ) )
Ensure the deadweight is present and in working condition.
3 3 ) )
Inspect the orifice.
4 4 ) )
Clean and replace components as necessary.
5 5 ) )
8 8 . . 2 2 2 2 I I n n s s p p e e c c t t L L a a t t c c h h , , C C a a t t c c h h a a n n d d S S p p r r i i n n g g
To make sure the latch, catch and latch spring are properly installed and are within
tolerances for safe operation. Refer to the
240
Annual Inspection Video on
O O b b j j e e c c t t i i v v e e
To make sure the latch, catch and latch
spring are properly installed and are
within tolerances for safe operation.
A. Catch
B. Latch
C. Latch Spring
C C a a t t c c h h I I n n s s p p e e c c t t i i o o n n
1. Slide gauge #162410 along the entire
width of the pot catch.
Vimeo.