Execute Mdi - WEIHONG 200 Series Manual

2. To enter into Motion Trace interface, press
3. To start simulating machining, press F1.
The moving trace of the machine tool shows in Motion Trace interface.
During simulating machining, you can also do the following:
• Press F3 / F4 / F5 to zoom in / zoom out / center the moving trace.
• Press F6 to clear the moving trace.
• Press F7 to stop simulating machining.

4.7 Execute MDI

This operation is used to directly enter at most 7 commands to control the system,
so as to perform fast movements, change system status or execute simple machining.
To execute MDI, do the following:
1. To enter into AUTO mode, press
上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
→ B:
.
35 / 52