WEIHONG 200 Series Manual page 18

To set speed parameters, do the following:
1. To enter into Machine Param interface, press
2. Press F2, and input the manufacturer password.
3. Press F1, find and set the following operation parameters:
JOG Jerk
Jerk under rapid-jog mode.
JOG Feedrate before Ref.
The default maximum feedrate in jog mode before returning to the machine
origin.
Manual High
The speed under rapid-jog mode.
Manual Low
The default speed under jog mode.
Max Spindle Speed
The maximum rotational speed of spindle.
It should be consistent with the settings of inverter.
Handwheel Acceleration
Handwheel acceleration.
Smaller value gets smoother handwheel movements.
4. Press F3, find and set the following program parameters:
Feedrate
The default feedrate during machining.
Machining Acceleration
The maximum acceleration for machining.
Max Speed of Ref. Circle
The maximal allowable speed of reference circle with 10mm diameter.
Max Acceleration at Corners
The maximum acceleration at corners.
Machining Jerk
Machining Jerk.
It is only valid on GXX.
上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
18 / 52
→ A.