WEIHONG 200 Series Manual page 19

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
Maximum Axial Feedrate
The default maximum feedrate of each axis during machining
Maximum Axial Rapid Traverse Speed
The maximum speed of each axis during positioning.
Max Axial Speed
The maximum speed of each axis.
Max Axial Machining Acceleration
The maximum acceleration of each axis during machining.
Max Axial Rapid Traverse Acceleration
The maximum acceleration of each axis during positioning.
Max Axial Jerk
The maximum axial jerk.
Startup Speed
The initial also the minimum speed during machining.
Circular Processing Min Speed
The minimum speed during machining an arc.
Max Acceleration at Feed Override Change
When feed override changes, smaller max acceleration gets smoother
movements.
Approaching F
During rapid positioning, the feedrate when the tool is approaching the
workpiece.
5. Press F5, find and set the following parameters about tool change:
Rapid Traverse Speed in Tool Change
The rapid traverse speed during tool change.
Z-axis Speed in Tool Change
The default speed at upper and lower position of Z-axis during tool change.
Horizontal Speed when Tool In/Out Tool Mag.
The default speed of Z-axis moving into/out of tool magazine during tool
change.
19 / 52