Simulate Machining - WEIHONG 200 Series Manual

5. To start machining the program task, press
The system automatically does the following according to the set machining order:
1. Load the first program file, start to machine it, and unload it when machining
ends.
2. Do one of the following:
– In One by One Mode, load the second program file, and wait for the set
interval, start to machine the program file, and unload it when
machining ends, repeat these steps until all program files in the program
task have been machined.
– In Single Mode, load the second program file, and enter into Pause
status.
It will not start to machine the second program file unless you press
manually.

4.6 Simulate Machining

This operation is used to provide a fast but lifelike simulation machining
environment to see the moving from of the machine tool in advance, so as to avoid
damages to the machine tool due to programming mistakes.
During simulating machining, no actual machining occurs.
To simulate machining, do the following:
1. To enter into AUTO mode, press
上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
.
.
34 / 52